Enter your email address and keep up with all the goings-on at Yakima.
Thank you for subscribing to Yakima's newsletter.
Rack Systems
Cargo
Bike
Water
Snow
Ask a Question
Catalog Request
Warranty Registration
Contact Us
The Yak Story
Design Philosophy
Yak Partners
Careers
Press Rooom
Road Warriors
Planet Payback
Yak Challenges
Yakimagrams
Yakywood
Bike Vigilantes
HOME
|
PRODUCTS
|
RACK SYSTEMS
|
NAKED ROOF
|
Q TOWER PAIR
MSRP:
$85.00 USD
| Product #
8000135
|
Buy Online
RackAttack
REI
ORS Racks Direct
Rack N Road
Rock Creek Outfitters
Campmor
Sun & Ski Sports
Rutabaga
Moosejaw
Q Towers are just your ticket. You see, 'Q' stands for the quadruple movement capability of the tower and clip. That gives it 4 degrees of freedom to better fit your car. And more freedom is always a good thing. So strike a blow for freedom. Buy some Q Towers today.
Die-cast interior for solid, sturdy anchor
Ball-and-socket mechanism adjusts to all contours of your vehicle. We know that sounds vaguely dirty, but it’s not
Add-vehicle specific
Q-Clips
(00601-00730) to ensure a custom fit to your doorframe (Do not confuse
Q-Clips
with similar-sounding personal hygiene products. Attempting to clean your ears with
Q-Clips
may result in serious Vincent Van Gogh-like injuries.)
Upgraded for easier and faster installation
Product # 0124
MSRP:
$85.00 USD
| Product #
8000135
|
Buy Online
Q Towers are just your ticket. You see, 'Q' stands for the quadruple movement capability of the tower and clip. That gives it 4 degrees of freedom to better fit your car. And more freedom is always a good thing. So strike a blow for freedom. Buy some Q Towers today.
Q: What else is needed?
A: You will need
Q-Clips
and crossbars. Check the fit list to see which clips and crossbar length is correct for your vehicle.
Q: Is there a way I can make it taller?
A: There is no way to make the towers taller.
Q: How much can I carry?
A: This varies by vehicle, load type and crossbar length. Check the fit list to find out what load types (bikes, skis, boats, etc.) and weight capacity applies to your car. The fit list will also tell you the best crossbar length (48", 58", 66", or 78") to use. You can go up one size if necessary, but duck your head.
Q: I have a factory rack, will the Q Towers still work?
A: Oftentimes it will. Look up your vehicle in the Fit List. If Q-towers are listed as an option for your vehicle with a factory rack then it should work. Also check for notes at the end of the listing to see if the factory rack causes any limitations.
Q: What sort of maintenance should I perform?
A: Performing maintenance is always a good idea to protect your car and make your rack system last longer. Lubricate nuts, screws, or bolts with grease. Lubricate locks with graphite. Remove the rack when not in use, or at least periodically to clean the pads and the vehicles roof. Clean the rack periodically, especially in marine environments and where road salt is used.
Q: How can I be sure the system is installed correctly?
A: There is no substitute for following all instructions. You can download instructions here. Be sure to perform both the Clip Safety Check and Tower Safety Check after every installation. The Q Clip instructions may have additional notes for your vehicle.
Q: Will the rack make a lot of noise?
A: Maybe. Wind noise is hard to predict, but it is more often an issue when the rack has little or no load. We make two products, the Fairing and Windjammer, to help control this situation. Large loads tend to dampen noise also. If you have a sunroof the fairing is a good way to help control air flow.
Q: Will it damage my car?
A: We take fitting cars very seriously, and do everything we can to minimize any effect our rack may have on your cars. However, anything coming into contact with a caR's finish, including our racks, will have some effect over time, and some cars are more prone to these issues than others. So where the possibility of such issues is predictable, we make note of that in the Fit List. When the rack will not be in use for an extended period, it is a good idea to take the rack off of the car. You can also do a lot for yourself by: (1) Making sure the car is clean and well waxed prior to installing the rack, (2) Following all instructions for installation and usage, and (3) avoiding situations, such as car washes, where the rack may be impacted.
Q: Do I need to drill into my car?
A: Nope, and you won't need any duct tape either.
Q: Where did the name "Q TowerS" come from?
A: We don't know. It seemed like a good idea at the time.
Q: What tools will I need?
A: A 6mm hex wrench, and it is included with the kit.
MSRP:
$85.00 USD
Product#:
8000135
Attaches load bars to vehicles using interchangeable clips. New, improved design features side-wedge tightening, and one-piece body.
Produced
: 2004 to present
History
: New design introduced in 2004 replaced part number 8000105.
June 2007 change to old style cam cover without integrated lock retaining clip.
General Information
:
Weight
: 3.97 lbs.
Dimensions
: 5-ΒΌ" from base to top of bar.
Capacity
: Varies by car. See Fit List.
We are commited to minimizing our impact on the environment.
Click
here
to learn more »
Q Towers
Q Stretch Kit
Q Clips
1A Raingutter
1A HiRise
1A HiRise Spacers
CrossBars
8007026
END CAPS
8810071
RPL, Q-CAM COVER ASSY
8810072
RPL, Q-CLIP VINYL PADS
8810073
RPL, Q-LOCK FASTENER
8810077
RPL, Q P-BALL, 8M FSTNRL
8870069
RPL, LOCK HSG, NEW QTWR
8880046
RPL, BAG, Q, LOCKS/CAPS, TPE
8880047
RPL, TWR, NEW Q-TWR, SINGLE
8880048
RPL, STRIPPED NEW Q-TWR
Copyright & Privacy Notice
| © 2008 Yakima Products, Inc. All Rights R eserved. (888) 925-4621.
